Recent content by nonsensez9

I haven't been surfing the forum all winter and now it's time to get my car ready for summer. I'm still diggin' Ultimate Compound and Swirl-X and have lots of it, but I'm curious about any new and improved otc sealant/waxes. Is clay still the best prep or has it been replaced? What's new for...

I'd like to hear opinions on aersol upholstry cleaners with a plastic brush attachment on the can? thumbs up? thumbs down? preferences?

I fluttered my credit card across the internet and ordered a Flex 3401. :woohoo: I have a quick question about random orbits in general: do you need to be careful around creases and corners, or simply go over them like they were flat?

I bought UPGP a couple months ago and now my car is ready for it's spring cleaning... problem is I lost the instructions. I recall something about priming the applicator with a couple squirts... after that is it to be sprayed directly on the paint or only on the applicator? thanks.

My camera broke so I used my phone :( Anyways... everything by PC. Hood got Danase SA2 with green pad followed by SA1 with white pad. The roof, trunk, fender flares, and upper doors - basically any other surface that would reflect the sun directly got SA3 with orange followed by SA1 with...

I've been so anxious to put my new products to use on the Mustang but the weather simply has not co-operated. So... I decided to do a little trial on the trunk of my '90 Beretta. This is NOT a correction attempt, but just a little before/after comparo using DWG, NXT, and NXT 2.0. Starting...

Any reason to use or not use a leather conditioner on coated leather? What about the pleather? thanks

OK... so it's bad mojo to use the magic eraser on leather. But can it be used on interior plastic trim. I have some marks that I cannot remove with soap and water. These would be tire marks that I got from hauling some spares around one day.

NXT 2.0 is not yet available in Canada and Autogeek is having difficulties getting the product stocked... and Meguiars doesn't ship to Canada. Are there any other e-stores that have NXT 2.0?

the only swirl remover polish that I've worked with is M83 & M80. Does anyone know the relative cutting strength of SA I, II, and III? And before anyone directs me to Bob, I have asked and he doesn't have recent experience with Megs.

I'm limited to the great outdoors when I polish so I'm looking for something that can be used in the sun. Are there products available?

What are some competing product of M83? While M83 did what I wanted it to, mostly, and with a bit of practice I'm sure it could do more. But I did find it difficult to work with. Dries fast and is hard to buff off.

....a whole lot better. Plus lessons learned from 1st time PC use suggestions welcomed process wash clay PC with M83 and Orange 6.5 inch pad (some areas 2 times) PC with M80 and White 6.5 inch pad PC with Blackfire Gloss Enhancing Polish and Black 6.5 inch pad hand applied...

I have a PC and orange, white, and black LC pads and some M80. Will that correct the paint on my '05 Mustang? Should I start with a milder polish? which pad to start with? thanks door quarter panel EDIT: looks like I'll have to get some 83 - when it's warm enough to do more...

Most every product I have says soemthing to the effect to avoid using in direct sunlight. Is that because of the heat, or are the products photosensitive? The reason I ask is that it is going to be about 45 degrees F when I polish this weekend. I'd like to get an early start, which means I...